The 150 mm version combines a handy size with extra height clearance, making it easier to position parts that require additional space above the tabletop. It is a practical stop for aligning profiles, panels, and components that need to be guided precisely along their length, while also leaving room for welding gaps and free torch movement.
The stop is placed into the grid holes with a system pin, and clamps are positioned according to the required hold. Its 150 mm height allows the edge to be guided above the tabletop, reducing accidental contact with other accessories and making the weld pool easier to observe. This setup works especially well when assembling door frames, panels, and parts prone to slight distortion under heat.
This size is highly versatile: low enough to avoid interference, but tall enough to provide stable support for longer edges. Repeatable referencing means fewer corrections after cooling, and setups can be easily reproduced in series production.
When you need extra clearance and more stable guidance for longer parts.
Yes, it is available in both variants – simply select the correct one when ordering.
Set them so the forces push the part against the stop rather than sliding it across the surface.
Yes, repeatable grid positions allow setups to be quickly reproduced in batch production.
Regularly remove spatter and chips, and use a light anti-spatter spray in the weld zone for easier cleaning.
English
Polski
